Types And Uses Of Low-carbon Steel Plates

Nov 18, 2024

Leave a message

Steel plates are usually divided into three types according to their thickness: thick plates (above 6mm), medium-thick plates (3-6mm) and thin plates (below 3mm).

In terms of plate making process, low-carbon steel plates can be divided into cold rolling and hot rolling. Hot rolling alone can produce low-carbon steel plates of about 1.2mm and stainless steel plates of about 2mm. Thinner plates are made by cold rolling, annealing and tempering rolling.
Cold-rolled steel plates
Cold-rolled steel plates are used for parts that require a large degree of plastic deformation of the material during part forming, and there should be no wrinkles, cracks, etc. on the surface. Different grades of steel plates are used for different parts. For example, the standards for Japanese automobile steel plates are divided into three categories. The first category (SPCC) is ordinary cold-rolled steel plates, which are usually rolled from boiling steel. The second category (SPCD) is steel plates for rolling, and the third category (SPCE or SPCEN) is cold-rolled steel plates for deep drawing.
In the past, rimmed steel was limited to unimportant stamping parts due to its large component segregation, unstable performance, and aging sensitivity. If aluminum-killed steel without aging is used, the cost will be 10-20% higher than that of general rimmed steel. In the past, skin-pass cold rolling was used to suppress the aging effect of rimmed steel plates, but in fact it only delayed the occurrence of aging. All countries are studying new improvement methods. The loose coil annealed steel plate (O.C.A) developed by the United States is a rimmed steel plate that is specially annealed in an atmosphere containing water vapor and hydrogen. Since annealing in this atmosphere can remove the solid solution and combined carbon in the carbide in the steel, it suppresses the aging sensitivity and further softens the steel plate. At the same time, due to the growth of recrystallized grains, the components of the {111} collective crystal arrangement parallel to the surface of the steel plate increase. According to the research of Armco Steel Company in the United States, this is related to improving the anisotropy of plastic deformation of steel plates, which improves the stamping formability of steel plates by 84%. In recent years, combined annealing steel plates (U.A.D.) have been developed on the basis of loose coil annealing steel plates. This is to weld several coils of steel plates into one coil and install them in a special annealing furnace for decarburization treatment. Its advantage is that it is less expensive than loose coil annealing. The steel plates treated in this way have been widely promoted in cold-rolled steel plates for stretching.
Hot-rolled steel plates
The manufacturing process is simpler than cold-rolled steel plates and the cost is also lower. However, foreign experience believes that the hot rolling method is only suitable for manufacturing steel plates with a thickness of more than 1.6 mm, and it is not economical for thinner steel plates. The surface quality and dimensional accuracy of hot-rolled steel plates are not as good as those of cold-rolled steel plates. In addition to frame longitudinal beams, cross beams and various brackets, hot-rolled steel plates on automobiles also require certain strength for stamping wheel rims, wheel discs, etc., as well as shell covers with low force and low surface requirements. The former is a 3-5 mm thick steel plate, while the latter is used for both medium and thin plates. The use of hot-rolled plates in automobiles is mostly thick plates. In the hot SLSN plate standard for automobiles formulated by the Japan Automobile Association, SAPH is used for beams and wheels, and SPH is a hot-rolled soft steel plate for manufacturing unstressed shells.
Recently, more and more hot-rolled steel plates abroad have been rolled using continuous cast steel slabs, and the surface quality of the steel plates has been continuously improved and stabilized. Coiled hot-rolled steel plates are also widely used.

Send Inquiry
Send Message