‌PPGI Process Flow

Nov 05, 2024

Leave a message

‌The process flow of PPGI (Pre-Painted Galvanized Iron) mainly includes the following steps‌: ‌Entrance Stage‌: The raw material coil is unrolled by the unwinder and then stitched by the stitching machine to ensure the continuity and consistency of the metal sheet‌. ‌Pretreatment Stage‌: It includes processes such as alkali degreasing, cleaning, passivation and baking. The purpose of these steps is to remove grease and impurities on the metal surface and improve corrosion resistance and adhesion to the primer‌. ‌Roller Painting Stage‌: It includes the initial application of primer and back coating (Primer & Back Coating), baking curing (Baking), finish coating (Finish Coating) and baking curing (Baking). In this stage, the paint is evenly applied to the metal surface by roller coating technology, and the paint film is cured by baking‌. ‌ ‌Exit Stage‌: Includes Outlet Looper, Cutting and Coiling. The coated steel sheet is coiled by the coiler and cut as needed to obtain the finished coil.
‌PPGI production process‌:

‌Raw material preparation‌: Use galvanized steel coils (GI/GL) with a size range of 800-1250mm×0.2-1.2mm‌.

‌Uncoiling and stitching‌: The raw material coil is uncoiled by the uncoiler and stitched by the stitching machine to ensure a continuous supply of metal sheets‌.

‌Pretreatment‌: Includes alkaline degreasing, cleaning, passivation and baking to improve corrosion resistance and adhesion to primer‌.

‌Coating‌: Ensure that the paint film is uniform and firm through the initial application of primer and back paint, fine coating of topcoat and baking curing‌.

‌Coiling and slitting‌: The coated steel plate is coiled by the coiler and slid as needed to obtain the finished coil.‌

Send Inquiry
Send Message